TAS PowerTek Ltd.
Leading through Technology

Automatic Power Factor Controllers (PF Controllers)

APFC-07 (Relay output)

PF ControllersEconomical value for money product
PF ControllersSmall size version in 96mm X 96mm
PF ControllersWide range Voltage supply 90Vac to 500Vac OR 100Vdc to 550Vdc
PF Controllers5Amp and 1Amp CT connection
PF Controllers Models available as 4, 6 & 8 relay contacts
PF Controllers Large Size LCD display
PF Controllers Protection to Capacitor Banks


PF Controllers User Manual  PF ControllersOperations Guidelines

Auto. P. F. LT Controller-Relay Output APFC-06

PF Controllers32-Bit ARM Cortex-Mx State-of-the-Art Technology Micro-Controller controlled Digital Signal Processing logic for
  measurements, monitoring, indication, alarming & controls.
PF ControllersPower Measurements with Class-3 accuracy as IEC62053- pt21 & 23. Auto CT polarity check (user editable)
PF ControllersPhase-to-Phase Measurement Voltage Feedback on independent Input Terminals.
PF ControllersSingle CT Supply (Load) Current Measurement Feedback on a Three-Terminal Side Connector at the Rear.

PF ControllersUser Manual   

APFC-03 (Relay output) & TPFC-03 (Transistor output)

PF ControllersFully Automatic Set-up
PF ControllersWide range Voltage supply 90Vac to 500Vac OR 100Vdc to 550Vdc
PF Controllers5Amp and 1Amp CT connection
PF ControllersMeasurement accuracy Class 1 for Voltage and Current. And Class 2 for Power (Active and Reactive)
PF ControllersMultifold Protections to Capacitor Banks
PF ControllersHigh speed switching transistor output for TPFC-03 to control high speed capacitor thyristor switches
PF ControllersExpert mode programming for finer aspects of PF compensation

PF ControllersUser Manual   PF ControllersOperations Guidelines

SPF-56 (Relay output) / TPF-56 (Transistor output)

PF Controllers3-ph (3W/4W) sensing with 3 CTs.
PF ControllersUnit with Communication capability on Serial (RS-232C/RS485HD),
PF ControllersWide range Voltage 90Vac to 500Vac OR 100Vdc to 550Vdc
PF Controllers5Amp and 1Amp CT connection
PF ControllersModels available up to 16 capacitor banks control
PF ControllersData Logging with user programmability
PF ControllersTPF-56 comes with high speed KVAR compensation capability
PF ControllersClass 1 Load manager functionality/div>

PF Controllers User Manual  PF ControllersOperations Guidelines

HTPF-56 (up to 33kV and 50MVA)

PF Controllers3-ph (3W/4W) sensing with 3 CTs. Additional 3 CT for capacitor current measurement
PF ControllersUnit with Communication capability on Serial(RS-232C/RS485HD), GSM/GPRS
PF ControllersSeparate measurement Voltage and wide range AC/DC auxiliary supply
PF Controllers5Amp and 1Amp CT connection for supply & capacitor current
PF ControllersModels available up to 8 capacitor banks control
PF ControllersData Logging with user programmability
PF ControllersClass 1 Load manager functionality

 

Automatic Power Factor Controller [ HTPF-03 ]

Totally Micro-controller controlled Digital Signal processing logic for measurements, monitoring, controls and logging etc.
Voltage & Current measurements with Class-2 accuracy.
Load V, I, and Cap. current THD measurement with odd harmonic coefficients up to 15th harmonic. Neutral current analysis too.
Various modes for switching, viz:
* Binary
* Un-equal (user defined)
* C-Series (preset series)
* E-Series (user defined)
Output banks control for 16 banks and 8 banks.
Capable of doing kVAr measurements every cycle of the mains waveform.


User Manual

Hand Held Unit (APFC DATA COMMUNICATOR)

Downloads four months logged data of Controller (APFC) into Hand Held Unit.
Fully Microcontroller based unit.
The captured data store into external Flash Memory (Micro SD card) which can store up to 999 controllers’ data.
Downloaded data can be fetched to PC from HHU via PC end software.
HHU can be used as a Firmware Downloader via JTAG Interface.
Portable unit.



User Manual

Auto-Manual Controller (AMC)

TAS Make Auto-Manual Controller (AMC) is an Intelligent Electronic Controller designed to allow the User to switch on or off the capacitor bank either automatically (command received from the APFC Controller as Input to the AMC) or manually, from the AMC front panel toggle switches.
TAS APFC Units also have a Manual Mode of Operation, it requires the User to operate the APFC Front Panel Switches and read the LCD Display to select the Capacitor Bank to be turned On or Off in the Manual Mode. However, some Users prefer operation with front-panel using conventional Toggle Switches. So, the AMC will provide them the comfort and ease of operations.


Auto Manual Controller